Due to the fact that the Bandwidth Splitter management tools integrate into the ISA Management console and the application management principles are alike, you can hardly have any problems with getting started with it.
|Warning. If the ISA Management console has stayed open during installation of Bandwidth Splitter, it is necessary to close and reopen it after installation to be able to access the new Bandwidth Splitter section.|
After Bandwidth Splitter has been installed, the ISA Management console looks as follows:
|ISA Management console with Bandwidth Splitter installed (click to enlarge figure)|
A new section, Bandwidth Splitter, has appeared in the console tree. This section includes the following subsections:
Initially Bandwidth Splitter contains no shaping or quota rules. By default such configuration means there are no restrictions for any traffic. And you won't see anything in monitoring section yet.
|Note. Bandwidth Splitter does not make it unnecessary to set up the basic options of ISA Server. Bandwidth Splitter only adds own rules to the set of already available in ISA Server. Therefore it is necessary to make sure that ISA Server is correctly configured before testing the new features provided by Bandwidth Splitter.|
Next you can set up Shaping Rules and Quota Rules at own discretion. For example, create a new shaping rule. Give it any name you wish.
At Applies To page specify users or IP address sets, to which this rule will apply.
|Warning. Bear in mind your license restrictions, and don't specify user groups or IP address sets that include more clients than your license allows.|
|Warning. If you want to apply Bandwidth Splitter rules to users or user groups (not IP address sets), those users must be authenticated by ISA Server. For this purpose they should be allowed in Firewall Policy access rules as authenticated users, that is at Users tab you should specify something other than All Users, for example All Authenticated Users.|
At Destinations page, select External network.
At Schedule page, select Always.
At Shaping page, select Shape total traffic (incoming+outgoing) and enter the maximum speed in kilobits per second into the field Total (kbits/s), for example 64.
Leave other fields with default values. Click Finish to complete wizard.
|Creating Shaping Rule (click to enlarge figure)|
Bandwidth Splitter stores its configuration in ISA Server storage. So when you make changes, you should apply them (or discard) when finished. You can do it using standard Apply and Discard buttons. When Bandwidth Splitter sections are selected those standard buttons are invisible, but you may use analogous buttons at toolbar. They look like this: .
Click Apply Changes button. Bandwidth Splitter will pick up the changes (may take a minute), and if some user was downloading a big file at an unlimited speed, and shaping rule you have just created applies to this user, the situation will change now and the speed for this user will be limited to 64 kbits/s. If the user has several open connections, this speed will be distributed evenly among all active connections.
|The effect of applying of Shaping Rules (click to enlarge figure)|
|Note. In Bandwidth Splitter monitoring you can see only connections to which some Shaping and/or Quota rule is applied. If neither Shaping nor Quota rule is found for some connections, they won't be filtered by Bandwidth Splitter, and you won't see them in monitoring.|
This was an introduction to Bandwidth Splitter. Read the rest of topics to learn more about the features and the use of Bandwidth Splitter.