Frequently Asked Questions

Q: Can I test Bandwidth Splitter on a virtual machine?
A: Yes, you can. However, shaping can be extremely inaccurate in such conditions, as problems with counting of small time periods may occur.

Q: Is it possible to temporarily disable Bandwidth Splitter without uninstalling it?
A: Yes, it is. To do so, disable its filters in the Application Filters and Web Filters lists and restart the firewall service. To resume operation of Bandwidth Splitter, enable these filters again and restart the firewall service again after that.

Q: I made shaping/quota rule for users, but it doesn't work, and I don't see these users in monitoring.
A: If you want to apply Bandwidth Splitter rules to users or user groups (not IP address sets), those users must be authenticated by Forefront TMG. For this purpose they should be allowed in Firewall Policy access rules as authenticated users, that is at Users tab you should specify something other than All Users, for example All Authenticated Users.

Q: Why some connections of SecureNAT clients are not visible in Bandwidth Splitter?
A: This could happen if Bandwidth Splitter Application Filter is not selected in protocol allowed to SecureNAT clients. By default, during installation Bandwidth Splitter selects itself in all defined TCP/UDP protocols. If after that you create new protocol and allow it to SecureNAT clients, you need to select Bandwidth Splitter Application Filter in it to enable processing of this protocol for SecureNAT clients by Bandwidth Splitter.

Q: When I run Forefront TMG Management console from remote computer, I don't see Bandwidth Splitter section.
A: You need to install Bandwidth Splitter remote management component on this computer. Just run Bandwidth Splitter installer on it, choose "Custom Installation" and select only "Administration add-on for Forefront TMG Management" component.

See also
© BNTC Software. All rights reserved.